Spares for Rio 400

Suitable for Rio 400, Vision 450.

All T5 light bars are sold WITHOUT light tubes. Please choose from the selection below.

Suitable for Rio 300, Rio 400, Delta 300, Trigon 350.

5 pieces per box.

Suitable for Rio 300, Rio 400, Delta 300, Trigon 350.

2 pieces in each box.

 

1 piece in each box.

Suitable for Rio 300, Rio 400, Delta 300, Trigon 350.

1 piece in each box.

Suitable for Rio 300, Rio 400, Delta 300, Trigon 350.

1 piece in each box.

Suitable for Rio 300, Rio 400, Delta 300, Trigon 350.

Delta 300, Rio 300, 400, Trigon 350

For Delta 300, Rio 240, Rio 300, Rio 400, Trigon 350, Vision 250, Vision 260

Delta 300, Rio 300, 400, Trigon 350.

For pumps 400, 600 and 1000

Will fit all pumps

The Juwel Aquarium Automatic Heater has been designed for use inside any aquarium as a main component of the Juwel filter system. If you do not have a Juwel filter system the heater comes supplied with suction cups to fasten the Automatic Heater to the glass pane of your aquarium.

If you do have a Juwel filter system you will position the heater inside the Filter Box ensuring that the heater is always positioned in the water flow and thus enabling an even distribution of warm filtered water. A heater holder is supplied to fit the heater into the filter system.

Suitable Rio 400

Additional light unit and 3 piece flap set.  Increases the light system to 4 tubes.

26mm. Suitable for all aquariums

Suitable for Rio 400

Suitable for Rio 400

Suitable for Rio 400. There is one reflector per box.

Aquarium	Number of reflectors
Rio 400	2

For reflectors 15W - 58W

For reflectors 15W - 58W

Note: Backgrounds are sold individually. All aquariums require 1 tube of silicone to glue the backrounds to the rear of the tank.

Aquarium	Number of backgrounds required
Rekord 70	1
Rio 300	3
Rio 400	3
Trigon 190	3
Trigon 350	3
Vision 260	3

Dimensions: 600mm x 550mm. Juwel Rocky backgrounds can be simply cut to size and attached to the rear of the aquarium from within using Juwel silicone adhesive.

Aquarium	Number of backgrounds required
Rekord 60	1
Rekord 70	1
Rio 240	2
Rio 300	2
Rio 400	3
Panorama 200	2
Vision 260	2
Vision 450	3
Trigon 190	2
Trigom 350	3

Dimensions: 600mm x 550mm. Juwel Rocky backgrounds can be simply cut to size and attached to the rear of the aquarium from within using Juwel silicone adhesive.

Aquarium	Number of backgrounds required
Rekord 60	1
Rekord 70	1
Rio 240	2
Rio 300	2
Rio 400	3
Panorama 200	2
Vision 260	2
Vision 450	3
Trigon 190	2
Trigom 350	3

Instructions for use

1. Remove the cap from the tube and screw on the nozzle. Cut off the tip of the nozzle.
2. Take care to ensure that the surfaces to be cemented are absolutely clean and dry before applying the silicon.
3. A dry skin forms on the surface of the silicone after just a few minutes. The silicone is firm after approx. one hour. Wait for 24 hours before filling the aquarium with water as only then will the silicone be fully hardened.
4. The tube must always be sealed well.
5. Only use in a well ventilated room to avoid the risk of eye irritation due to acetic acid separating off. Always wash your hands after use. Avoid eye contact.
6. Silicone must be kept out of children's reach.
7. fresh silicone can be removed with Acelan or similar solvents. Fully hardened material can only be removed by physical means.

For Delta 300 (front light unit), Panorama 100, 200, Rekord 70, 96, 120, Rio 180, 240, 300, 400, Vision 250.